Guide

Draughty, Misted or Rotten? Diagnosing Old Windows

Match the symptom to the likely fault: a draught, a misted pane or a soft sill each point to a different fix, and only some of them mean new windows.

Illustration of three windows side by side: one with wind lines at its edge, one with a misted pane and one with a dark rotten sill, with a magnifying glass over the middle one

Old windows give you a symptom, not a diagnosis. A draught, a misted pane and a damp sill all feel like "the windows are bad", but they have different causes and different fixes. Find the symptom below and read across to what it usually means.

Find your symptom

Symptoms and what they usually point to

What you noticeLikely causeUsual fix
Cold air round a closed windowWorn seals, dropped sash or shrunken frameNew seals or hinges, or replacement if the frame has moved
Mist between the panesFailed sealed unitNew glass unit, or new window if the frame is also tired
Mist on the room sideMoisture in the room, not a window faultVentilation first
Soft, dark or flaking timberWater getting in, often at the sillRepair for small areas, replacement for widespread rot
Yellow or chalky uPVCAge and sunlightCosmetic. Replace only if the frame is also failing
Sash that will not stay openWorn balances or broken cordRepair is usually possible
Handle turns but window does not lockWorn locking gearNew hardware if it can be sourced

Draughts

A draught is not always the window's fault. Gaps in the plaster or sealant around the frame, an unsealed letterbox or a loose cill can all be to blame. Close the window, hold a thin strip of paper against the frame edge and see if it moves. If the draught is from the opening sash itself, new gaskets or adjusted hinges can often fix it. If the whole frame has twisted, or the old gaskets are not made any more, it is probably cheaper to replace.

Misted double glazing

Moisture trapped between two panes means the seal around the glass unit has failed. That is a glass problem, not a frame problem. If the frames are in good shape, the sealed unit can be swapped without replacing the window. If the frames are tired, replacing the whole window makes more sense. Condensation on the room side or outside of the glass is a different matter, and usually points to damp air in the room rather than a window fault.

Rotten timber

Push a screwdriver tip into the sill and the bottom of each frame. If it goes in easily, the timber is wet and soft. A small area can be cut out and filled. Widespread rot, or rot on the main frame, is rarely worth chasing. In that case, price new wooden windows alongside alternatives such as uPVC or composite.

Exposure plays a part

Norfolk's coast and open fenland are hard on windows. Salt, driving rain and wind loosen seals faster and attack cheap hardware. If your house is on a headland or across open marsh, expect the south-west and north-east elevations to wear first, and choose replacement frames and finishes with that in mind.

Do not fix one fault and ignore the rest

A new sealed unit in a rotten frame, or new hinges on a warped sash, rarely lasts. Look at the whole window before paying for a single repair.

Doors have the same problems

Doors suffer from dropped hinges, cold threshold gaps and worn locks. If a door will not close without a shove or shows daylight along its edge, look at door replacement as well. For help with prices, see the replacement window cost guide and our uPVC guide.

How to find out what is wrong with an old window

  1. Name the symptom

    Decide whether the problem is a draught, mist between the panes, mist on the glass surface, soft timber or a hardware fault.

  2. Test for draughts

    Close the window and hold a strip of paper against the frame edge. If it moves, note where.

  3. Inspect the glass

    Check whether moisture or a milky film sits between the panes, which points to a failed sealed unit.

  4. Probe the timber

    Press a screwdriver tip into the sill and the lower frame to find soft areas.

  5. Decide on repair or replacement

    A single fault in a sound frame can usually be repaired. Several faults, or a damaged frame, usually point to replacement.

Frequently asked questions

Why is my double glazing misting up between the panes?

The seal around the glass unit has failed and let moisture in. The unit usually needs replacing, though the frame can often stay.

Can draughty windows be fixed?

Often, yes. New gaskets, adjusted hinges or fresh sealant around the frame can cure many draughts. A warped or twisted frame is harder to fix.

How can I tell if timber windows are rotten?

Press a screwdriver tip into the sill and lower frame. If it sinks in easily, or the wood crumbles, the timber is likely to be rotten.

Is it worth repairing old windows?

It depends on the fault and the state of the frame. Single faults in a sound frame are often worth repairing. Multiple problems usually mean replacement is better value.

Ready to talk to a double glazed window replacement specialist?

Get Free Quotes →